Tygarbyte Blog

A blog about what interest me

35 Stagea Key Programing

Introduction FIRST code it to your car using your existing Key Blade and with the instructions below. THEN get it cut by a locksmith. Note: You must have all remotes on hand when performing this procedure. Any remotes not used during this procedure will become inactive. 1. Close and lock all doors with the driver’s side power lock switch located on drivers door panel. Insert your key (can be a plain key blade, does not have to be a remote one) into ignition (DON’T TURN) and remove it from the ignition key cylinder at least 6 times within 10 seconds (this will need to be done at approximately one second intervals). Read more...